混流泵
离心泵
1、离心泵的工作原理
水泵开动前,先将泵和进水管灌满水,水泵运转后,湘乡市混流泵采购价,在叶轮高速旋转而产生的离心力的作用下,叶轮流道里的水被甩向四周,机械密封混流泵采购价,压入蜗壳,叶轮入口形成真空,排涝混流泵采购价,水池的水在外界大气压力下沿吸水管被吸入补充了这个空间。继而吸入的水又被叶轮甩出经蜗壳而进入出水管。由此可见,若离心泵叶轮不断旋转,则可连续吸水、压水,水便可源源不断地从低处扬到高处或远方。综上所述,离心泵是由于在叶轮的高速旋转所产生的离心力的作用下,将水提向高处的,故称离心泵。
(一) 型号说明:
以250HW-8为例:
250—泵进(出)水口直径为250毫米。
8—泵总扬程为8米。
III. Type Instruction:
Take 250HW-8 for an example:
250-The diameter of inlet /outlet of pump is 250mm.
8-The total head of pump is 8m.
3、水泵出水量不足
The waer yield
of water is not enough
1、进水管路或叶轮有水草杂物
2、转速过低
3、输水高度过高
4、泵盖及叶轮磨损间隙过大
5、填料进气
6、马力不足
7、进水管口插入水中深度不够
1. There are waterweeds and sundries in
inlet pipes or impeller
2.The rotate speed is too low
3.Water delivery height is too high
4.The attrition gap between pump cover
and impeller is too large
5.The padding is air in
6.The horsepower is not engough
7.The depth of inlet pipe under water is
not enough
1、清除水草杂物
2、调整转数
3、降低输水高度
4、用纸垫调整间隙至正常
5、压紧或更换填料
6、加大马力
7、增加插入水中深度至一米左右
1.Clear the waterweeds and sundries
2.Ajust the rotate speed
3.Reduce the water delivery height
4.Add paper washers to adjust the gaps
pact or change padding
6.Increase the horsepower
7.Make the depth of inlet pipe under
water to one meter