混流泵
5、水泵有杂音或振动
There is noise
in pump or the pump is vibrating
1、轴中心没有对正
2、轴弯曲轴承磨损过大
3、叶轮平衡性差
4、地脚螺栓松动
5、装置不当
6、叶轮局部阻塞
7、吸水高度太高、发生汽蚀
8、泵内掉进杂物
1.The axile center is not aligning
2.The axile is bend,球铁混流泵销售价, the bearing wears
much
3.The balance of impeller is not good
4.The foundation bolts are loose
5.The assembly is improper
6.Part of the impeller is blocked
7.The suction head is too high to produce
cavitation
8.There are sundries in pump.
1、找正
2、校正或更换轴承
3、进行静平衡试验和调整
4、拧紧
5、检查机组
6、消除杂物
7、降低安装位置减低安装高度
8、清除杂物
1.Calibrate
2.Calibrate it or change the bearing
3.Do the static balancing test and adjust
it
4.Tighten it
5.Check the pump unit
6.Remove the sundries
7.Reduce the installation site to reduce
the installation height
8. Remove the sundries
用户选择水泵时,龙游混流泵销售价,较 是到农机部门认可的销售点,一定要认清生产厂家。建议**考虑购买充水式潜水电泵,并且看清牌号和产品质量合格证。千万不能购买“三无”(即无生产厂家、无生产日期、无生产许可证)产品,否则出现了问题,用户将束手无策。
作为用户,由于受到专业知识的局限,很难定夺,较 靠而又比较成熟的产品,不失为一种明智的选择。同时,应根据当地的电源情况来决定用单相泵或三相泵。
机械方面
电机和水泵转动部件质量不平衡、粗制滥造、安装质量不良、机组轴线不对称、摆度**过允许值,零部件的机械强度和刚度较差、轴承和密封部件磨损破坏,不锈钢混流泵销售价,以及水泵临界转速出现与机组固有频率一直引起的共振等,都会产生强烈的振动和噪音。
水力方面
水泵控制阀水泵进口流速和压力分布不均匀,泵进出口工作液体的压力脉动、液体绕流、偏流和脱流,农业混流泵销售价,非定额工况以及各种原因引起的水泵汽蚀等,都是常见的引起泵机组振动的原因。水泵启动和停机、阀门启闭、工况改变以及事故紧急停机等动态过渡过程造成的输水管道内压力急剧变化和水锤作用等,也常常导致泵房和机组产生振动